不锈钢橱柜有什么优点?・真正的0甲醛・台面一体化,永远不会开裂・不怕火不怕水・抗冲击好,硬度强・不变色好清理・可回收What does the advantage of stainless steel cabinet have?Real, 0-formaldehydeMesa is i ...
不锈钢橱柜有什么优点? ・真正的0甲醛 ・台面一体化,永远不会开裂 ・不怕火不怕水 ・抗冲击好,硬度强 ・不变色好清理 ・可回收 What does the advantage of stainless steel cabinet have? Real, 0-formaldehyde Mesa is integrated, never crack Not afraid of fire or water Good impact resistance and strong hardness Never change color and then clean it up ・ callable preferred stock 市面上SUS304不锈钢价格普遍企高,不锈钢橱柜价格为什么这么贵? The SUS304 stainless steel price on the market is generally high, why does the stainless steel cabinet price is so expensive? 01 不锈钢橱柜全身不含一丝木头,从里到全部使用食品级304不锈钢为原料(除五金连接件)。304不锈钢是国家规定的可以用来烹饪盛放食品的不锈钢钢种,卫生安全等级较高。 Stainless steel cabinets do not contain a trace of wood, from inside to all the use of food grade 304 stainless steel as raw material (except for the hardware connector).304 Stainless steel is a national prescribed stainless steel steel can be used to cook food, health and safety level is higher. ▲食品类钢材 ▲ food steel 02 304不锈钢密度较大,不易生锈,热容十分不错,不管是热锅滚油还是-78.5℃的干冰冒菜,统统不会对它造成损害。 304 Stainless steel is high density, not easy to rust, the heat capacity is very good, whether it is a hot pot rolling oil or-78.5℃ of dry ice steaming food, all will not cause damage to it. 03 304和201均为不锈钢的代号,两种钢材肉眼几乎无法区分,但304价格更高,质量更好,耐酸碱腐蚀性能远好于201。 钢板的厚度直接决定了不锈钢橱柜的品质,越厚的价格越高,市场上好的品牌会自觉采用1mm~2mm厚度的不锈钢板,这个厚度就算是中空也完全不用担心承重支撑力不足。因此,对于不锈钢橱柜来说,没有填充物或者尽可能少填充物才是最好的。但达到1mm厚度的钢材价格就不便宜了。 304 and 201 are both code names for stainless steel. The two steel products are almost indistinguishable by the naked eye, but 304 has a higher price, better quality, and its acid and alkali corrosion resistance is far better than 201. The thickness of steel plate directly determines the quality of stainless steel cabinet, the thicker the price of the higher, the good brand on the market will consciously use 1mm~2mm thickness of stainless steel plate, this thickness is hollow also need not worry about load-bearing support.Therefore, for stainless steel cabinets, there are no fillers or as little fillers as possible is the best.But steel of 1mm thickness is not cheap. |